If you are looking for a Jeep bumper that gives you the front-end protection of a full width bumper, then take a look at the Full Width Front Jeep Bumper from Steelcraft! It lines up nicely with OE front fenders and gives you that extra front-end protection that a stubby bumper cannot provide. It boasts a sleek design built from sturdy 10-gauge steel and will hold its own against the elements with black powdercoat finish.
The Steelcraft Full Width Front Jeep Bumper features a spot for mounting round offroad lights as well as factory fog lights on each side. These bumpers can also accommodate a 20" LED double row light bar and up to a 10,000 lb winch (all accessories sold separately). It even has a removable hoop and integrated shackle mounts that are included with this bumper. There is also a rear bumper to match!
Additionally, the Steelcraft Full Width Front Jeep Bumper will come with everything needed to get this bumper installed on your Jeep, and is covered against manufacturer defects in materials or workmanship for two years.
|WARRANTY||2 Year Limited Warranty|
Steelcraft bumpers come complete with installation instructions. Because of the size and weight of these bumpers, they can be heavy to lift. When it comes to mounting, it is recommended that you have help with the lifting of the rear bumper to avoid injury or damage to bumper and vehicle. However, they come with a no-drill, bolt on mount kit for easy installation. Recheck all hardware after the first couple hundred miles. It is advised to inspect the bumper and hardware periodically. For additional information, please give us a call!
Steelcraft guarantees the original purchaser a LIMITED 2 YEAR WARRANTY from the date of purchase against manufactured defects in materials, workmanship, and finish under normal use. This excludes damage resulting from road hazards, debris, product misuse, improper installation, impairments from accidents, neglect, shipping, or product modification. This warranty applies only to new products and is limited to the repair or replacement of Steelcraft products. Warranty does not include the cost of removal, installation, labor, freight, inconvenience, or consequential damage. The original purchaser must return defective merchandise to the original place of purchase and must provide an original receipt.
Steelcraft products are designed as decorative accessories and should not be relied upon as protection for the vehicle or passengers. Buyers assume all risk and liability whatsoever resulting from the installation and use of Steelcraft products. Steelcraft assumes no liability for injury, loss, incidental or consequential damages in the event of an accident.
Steelcraft products should be routinely cleaned with a mild soap and water solution then dried fully with a clean dry terry cloth. Powdercoated products have a similar consistency as automotive paints and should be cared for similarly. Stainless Steel products require routine cleaning and polishing with a non-abrasive polish. Failure to do so may cause fading, corrosion, and ultimately void product warranty.