- Available in Angled or Spacer
- Includes Set of 8 with Adhesive Installed
- Spacer Shims: 1/8" x 1-1/2" x 6"
- Angled Shims: 1/8" x 1/2" x 6" or 1/16" x 1/2" x 6"
Shims are included with select BAKFlip rails or Revolver X2 and can also be utilized to adjust how tight the cover will fit between the rail opening. These are typically included on trucks models that come standard with a painted bed rail and no plastic bed cap protectors.
Available in Angled or Spacer. Includes: Set of 8 with Adhesive.
Works with Revolver X2, BAKFlip F1, BAKFlip G2, BAKFlip HD, BAKFlip FiberMax, BAKFlip VP, BAKFlip Endura, BAKFlip CS, BAKFlip CS-F1.
Installing the BAKFlip or Revolver X2 rails square to the truck bed rail is the key to a successful installation.
FIG 1: Some trucks have an indentation in the lower section of the bed rail (adding angle shims to the truck bed rail will be necessary.) Position an angle shim at each clamp position.
FIG 2: Some trucks have a tapered clamping surface on the truck bed rail (adding angle shims to the truck bed rail will be necessary.) Position an angle shim at each clamp position.
FIG 3: Some trucks have a square bed rail (no angle shims needed.)
When needed, the angle shims are applied to the truck bed rail to prevent the BAKFlip rail from tilting when clamped in place. A squarely clamped rail ensures proper latching and sealing of the cover.
*SEE ILLUSTRATIONS AND REFER TO THE ATTACHED DOCUMENT TO DETERMINE IF YOUR VEHICLE NEEDS ANGLE SHIMS AND PROPER PLACEMENT AS NEEDED